OriGENE2: total spine rehabilitation

The existing OriGENE1 focuses on the treatment of (chronic) low back pain. This treatment device is now used in the Netherlands at approximately 100 physiotherapy practices used. The OriGENE2 goes a step further and allows treatment of the entire spine, from tailbone to crown, in 1 device. Both integrally, as well as for low back, high back and neck complaints. It was developed in the Netherlands during 2014 - 2017, also under the guidance of sports doctor Frank Bertina. The treatment is performed under 1-on-1 guidance and supervision of your physiotherapist on the OriGENE treatment device. Watch the video below for a further explanation. 

OriGENE2

From OriGENE1 to OriGENE2, the treatment of back and neck pain

The ideas behind the development of the OriGENE2 are:

  1. that there are few treatment options in the field of high back and neck pain
  2. That you can exercise/treat the lower back even better by also including the top of the spine,
  3. That you can treat neck pain better by also including the lower part of the spine. By doing so, we aim to improve the integral control of all muscles around the spine. Isolated training of only the neck is also possible, but does not offer this advantage.

The OriGENE2 thus enables treatment of the entire spine, from tailbone to crown, in one device. Both integrally, as well as for low back, high back and neck complaints.

OriGENE2

The technology and features

Using this new device, you can achieve optimal functional movement with the entire back. To do this, the device combines three key features:

  1. The stretching movement of the back is completely isolated (as in OriGENE1) by making ulterior movements of legs, hips and pelvis impossible. As a result, you cannot compensate.
  2. Parallel to the load on the lower back via the shoulder roll, a load independent of this now takes place on the top of the spine. To this end, a separate support is placed against the back of the head, which is used to lift a separate weight stack via a second axis over the same pivot point.
  3. The nature of the training load, which the device now imposes across the entire spine, can be fully adapted to the patient's individual capabilities and limitations. The physiotherapist achieves this by using no fewer than 11 different setting variables on the device, all of which interact. In other words: you move and train the entire back and/or neck over the entire range of motion with optimal resistance adapted to your individual situation. The device thus enables isotonic loading (an even tension of the muscles involved) over the entire Range of Motion, over the entire spine.

No other treatment device has these capabilities. A European Patent has therefore been granted on this invention.5

OriGENE2

Also for neck and high back pain

The new device has been field-tested at two locations for about a year and a half, with good results. The majority of our back patients experience the combined exercise as complete, safe and logical. For people with neck and (high) thoracic complaints, this device offers new possibilities. A new target group, therefore, because until now treatment options for the high back and neck were very limited.

Experiences with the OriGENE2. In conversation with Edwin Glerum Msc (physio- and manual therapist) and Sebastiaan de Lange (physiotherapist) from Reva Centre Heiloo. Watch the video here. 

For people with low back pain, where movement restriction predominates and there are no problems higher up in the vertebral bowl, the OriGENE1 sometimes remains the more efficient solution due to its simpler movement. Therefore, it is possible for the treating physiotherapist to convert the OriGENE2 back to an OriGENE1 in no time.

Where

Look at treatment locations to see where the OriGENE2 is available. Should you have any questions as a result of the above you can send them to here pose.